I have a basic loom for a project car (which will need to go through IVA) but I'm looking to make a number of changes before fitting.
Electric Fuel Pump (with safety links to engine)
Heat Windscreen
Heated Seats
Direct feed for headlights
Fog light controller
Rev Light (with fog light cutout)
DRLs and controller
Brake fluid level warning
and a few other bits and bobs too.
I know I can sit with a colored pencils etc, but the end result would be a one off; with a soft version I can print it off, make changes and the like without the need to rub things out and/or start again.
I've got a few sketches of what I need to do for the individual components but was wonder if anyone knew of some (ideally) free software that's available that can be used to draw up the complete loom?
Electric Fuel Pump (with safety links to engine)
Heat Windscreen
Heated Seats
Direct feed for headlights
Fog light controller
Rev Light (with fog light cutout)
DRLs and controller
Brake fluid level warning
and a few other bits and bobs too.
I know I can sit with a colored pencils etc, but the end result would be a one off; with a soft version I can print it off, make changes and the like without the need to rub things out and/or start again.
I've got a few sketches of what I need to do for the individual components but was wonder if anyone knew of some (ideally) free software that's available that can be used to draw up the complete loom?